These commands break a gap of a fixed width in a straight edged entity such as a wall made with the Wall button. The gap appears on either side of the selected point. The gap can then be left as it is, or you can insert symbols or other entities in the gaps.
To break a gap of user width in a wall, select Dungeon > Wallbreaks, Center > User Width
1 The prompt says "Width of break[3]:" Type a width, select two points the correct distance apart or press the right button to accept the default value (3 the first time, the last selected value thereafter)
2 The prompt reads "Select entity:". Select a straight edged entity. Make sure that there is enough space on either side of the selection point to fit the gap in.
3 The prompt reads "Select entity:" again. Press the right button to complete the command or select another wall section on the same or a different wall.
Note: This (and Wallbreak, End > User Width) is the only way to break gaps in metric values on metric templates.
), 5’ 10’ wideTo break a gap of fixed width in a wall select Dungeon > Wallbreaks, Center > 3’, 5’ 10’ wide
1 The prompt reads "Select entity:". Select a straight edged entity. Make sure that there is enough space on either side of the selection point to fit the gap in.
2 The prompt reads "Select entity:" again. Press the right button to complete the command or select another wall section on the same or a different wall.
Related Topics